Great, thank you!
Great, thank you!
Apart from the “smooth steps”, there has since been one more material change: the channel mode for the strobe modes is now individually saved per strobe mode. This allows to set a different channel mode for each suitable strobe mode.
This change was introduced with revision 753, 2023-08-24, and documented in the text manual with revision 783, 2023-10-12.
I have checked with Emisar D2, running ToyKeeper’s latest release, anduril.2023-10-01.emisar-2ch.hex, and indeed, the channel mode is saved per strobe mode. So this is working.
This would be an addition to the Advanced UI diagram: “saved per strobe mode” could be added in Strobe Modes Actions 3C, which could then for example read 3C: Next channel mode (except Police Strobe), saved per strobe mode
.
In addition, here comes a slight detail for consistency in the Advanced UI diagram: in Blinky/Utility Modes, it should maybe read Thermal Config
instead of currently Thermal Configuration
, as everywhere else in the diagram, it reads Config
.
Hi, I just checked with Emisar D2, running the lastest release 2023-12-03, and all is working as displayed on the diagram. From
ON
, 10H leads to Ramp Extras Config (forAdvanced UI
), with 4 Turbo style setting. FromON
, for 7H there is no 4 Turbo style setting. FromOFF
, 10H leads toconfig Simple UI
, and there is 4 Turbo setting (forSimple UI
). There is no redundant Turbo style setting, as one is forAdvanced UI
, and the other is forSimple UI
.Maybe some confusion is caused because both 7H from
ON
(config current ramp) as well as 10H fromOFF
(config Simple UI) lead toRamp Config
, but this way, some space can be saved on the diagram page layout, because there is no need to display two separateRamp Config
textboxes. InRamp Config
, after 4 Turbo style setting, in the diagram(only 10H)
is displayed, indicating that this setting is only forconfig Simple UI
, 10H fromOFF
.I am hopeful that this addresses the issue, and may have clarified things. :)